HOW TO FIT GUIDE
Please see below a detailed video, quick steps and a detailed walkthrough of how to fit your hair piece.
So, let's get started.
Quick step
- Let's get ready.
1. Blow-dry and style your hair as normal.
2. Take a halo section of hair roughly 2-3cm from the hairline and at an angle sloping down towards the back of the head and pin the hair up.
3. Hold your Nothing 2 See front halo hairpiece up and put it over the sectioned out hair and place it on the head making sure the elastic is at the back of your head.
4. Take a tail comb and slide the tail of the comb around the band removing any hairs that may be trapped under it
5. Take the hair down that you have pinned up and gently comb and style hair into place. When combing into place put your fingers on your Nothing 2 See front halo Hairpiece at the top when combing each side as this will help to keep it in place in case you hit a knot in your hair, so it doesn’t pull.
6. Your ready to go!
Fitting Steps
In your box
On opening your box, you will find your gorgeous Nothing 2 See front hairpiece along with a single use glue and a spare wire and beads.
Take your Nothing 2 See front halo hairpiece and you will see at the back the clear wire attached with a bead on either side.
On one side the bead is flat and on the other side the bead is open with a tail of clear wire allowing you to change the size of your hairpiece.
Section the top of your hair out leaving around 2-3 cms out around the front hairline.
Clip the hair out of the way using a clip or hairband, so it is out of the way.
Place the Nothing 2 See front halo hairpiece over the head so it sits below the hair you have sectioned out.
The clear band should be sitting just under where your head naturally curves and feels like it sticks out which is known as the occipital bone.
Once your hair piece is in position at the top and back you can now start personalising to your head shape. You can do this by going to the side of the hairpiece where the bead is open.
To make the hairpiece bigger, hold the open bead and gently pull the clear wire which is closest to the head this will lengthen the clear wire. If you want to make the hairpiece smaller hold the open bead and gently start to pull the tail of the clear wire until it feels like it is more fitted to the head, (making sure you can still fit a finger easily under the clear wire at the back) this makes sure the band isn’t too tight.
Once the sizing is correct and feels secure take your hair pliers and firmly squeeze the bead making sure the bead is completely flattened and secured.
Once the Nothing 2 See front halo hairpiece is fitted and comfortable this is when you can put your parting in.
*(If you have a fringe and are using it to help thicken your fringe you do not need to put a parting in or remove any hair).
Pinch the hair in your fingers where the parting needs to go then take your Nothing 2 See front halo hairpiece off keeping hold of where you need to remove the hair.
Spray with water (this helps to soften the knot slightly) then gently wiggle the hair and you will need either a pair of tweezers or a needle to gently remove the hair and create a parting.
Once you have cleared the hair on the parting take the glue and snip the end off. Put a small drop on either side of the hair where it has been partied to secure the hair in place and leave to dry for a couple of minutes.
Once the glue is dry you are now ready to get your Nothing 2 See front halo hairpiece customised.
We recommend all fitting and customisation with the cut and colour to be done by a professional.
Follow Us On...